1. The site is measured, and an appropriate 'line' agreed for the fence position.

2. The required spacing for the clamps is assessed, and a small core hole drilled for each clamp.

3. After the holes have been drilled the clamps are secured to the glass sheets and placed into the holes with preset height blocks under the glass.

4. All the sheets are propped into place then height is readjusted, spacings are set and alignment is carried out.

5. When these are correctly adjusted the clamps are secured into the holes with the provided epoxy to a suitable level allowing room for grouting around the clamp.

6. The alignment is rechecked and adjusted if necessary with the packers and shims.

7. Finally a matching grout is applied to the last 10mm or an optional stainless steel cover plate is fitted.