 Our Frameless Glass Fencing System provides a great looking Frameless Glass
Fence using 12 mm toughened glass which can be installed into most situations
without additional site preparation. Its versatility allows it to be used in
so many situations which were previously considered impossible for glass, let
alone Frameless Glass.
Gates are attached directly to the glass with the gate operator recessed into
the floor providing a functional yet neat & clean overall effect.
Some difficult
situations which are easily handled are:-
- Stairs Terraced areas
- Through garden beds and water features
- Onto and over hobs etc
- Sloping ground
- Areas where water needs to run under the fence
- Existing sites ...
|
|
We have solutions for a multitude of pool fencing and balustrading situations
...
-
Onto the top of paving or concrete.
- Onto the side of slabs with and without
coping overhangs.
- Onto the top or sides of balcony and other hobs.
- Onto
decks, timber or steel.
- Through gardens or lawns
- Up and down stairs
- Over
walls or obstructions
- Along suitable walls.
If you have a 'problem area' where you want to install our Frameless Glass
Fencing system just call and we will provide free Technical advice for your
situation. In some cases we may need a plan and detail of the area concerned
so that we can give you the best solution.
|
|
Read more...
|
|
Our patented Glass Fencing and Ballustrade solutions are easily installed by a professional or an experienced handyman.
1. The site is measured, and an appropriate 'line' agreed for the fence position.
2. The required spacing for the clamps is assessed, and a small core hole drilled
for each clamp.
3. After the holes have been drilled the clamps are secured to the glass sheets
and placed into the holes with preset height blocks under the glass.
4. All the sheets are propped into place then height is readjusted, spacings
are set and alignment is carried out.
5. When these are correctly adjusted the clamps are secured into the holes
with the provided epoxy to a suitable level allowing room for grouting around
the clamp.
6. The alignment is rechecked and adjusted if necessary with the packers and
shims.
7. Finally a matching grout is applied to the last 10mm or an optional stainless
steel cover plate is fitted.
|
|
|
Glass Fencing 
